Products > Test Equipment
Siglent SDM3065X
analogRF:
--- Quote from: kj7e on May 26, 2018, 03:08:47 pm ---Ive had both the SDM3055 and SDM3065, both where calibrated from the factory bang on and worked quite well. They are good meters for the price. My experience has been, Siglent seems to do a proper job with their factory calibrations.
As pointed out, my first SDM3055 had an issue, I never even removed the plastic wrapping as I could hear something rattling inside the meter when I unboxed it. The distributor I bought it from was not as helpful as I would have liked, but Siglent USA stepped in and quickly resolved the issue.
--- End quote ---
I am having difficulty in choosing between SDM3065X and Rigol DM3068. Any advice? are you happy with it? any pros or cons?
I hear many people complain about the siglent being very slow and sluggish. I also have two specific questions: is the capacitance resolution 4 decimal digit or 3 at lowest range? In reading hold mode can you adjust the sensitivity of capturing a new reading?
tautech:
--- Quote from: analogRF on September 06, 2018, 05:16:18 am ---I am having difficulty in choosing between SDM3065X and Rigol DM3068. Any advice? are you happy with it? any pros or cons?
I hear many people complain about the siglent being very slow and sluggish.
--- End quote ---
The earliest releases were troublesome until firmware became mature and this only applies to early 3055 FW.
You cannot judge the 3065X on 3055 old commentary, one they are entirely different units and two, they run different FW.
--- Quote ---I also have two specific questions: is the capacitance resolution 4 decimal digit or 3 at lowest range?
--- End quote ---
C measurement.
22pF, 50V 5% NPO disc ceramic.
ST3 Smart Tweezers measurement 26-26.1pF
SDM3065X, 5 digits available on 2nF range
4 wire measurement, leads nulled.
--- Quote ---In reading hold mode can you adjust the sensitivity of capturing a new reading?
--- End quote ---
No, not while in a Manual range setting with the Range buttons below the display.
In the Hold GUI you must select; Probe Hold=OFF then the range selection buttons become available.
Then re-enter the Hold UI with a press of Shift and Single/Hold.
skander36:
Hi Tautech ,
How can I modify files definition for K Type thermocouple in SDM3065X . It show a lower temp - 18* instead of 23* C .
Thank you !
tautech:
--- Quote from: skander36 on December 06, 2018, 12:04:34 am ---Hi Tautech ,
How can I modify files definition for K Type thermocouple in SDM3065X . It show a lower temp - 18* instead of 23* C .
Thank you !
--- End quote ---
Didn't know so had a look.....
In the Temp UI select the Load softkey and the right arrow key to select the correct file for your probe.
In the Load menu after selecting the correct File, press Read to check your thermocouple measurement File is a correct match for your probe.
Or you can use Define for which there are 128 offset corrections available.
skander36:
Hi,
Thank you , but how can I use values from Define ?
Everything I choose don't change anything .
Thank you !
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version