Products > Test Equipment
Siglent SDS-1202X-e waveform issues
<< < (4/8) > >>
JiaRen:
My friend that sent me the gift said that the Main board must have been damaged during shipment. Best bet now is to get a replacement board from siglent.
tautech:
Ok so have you checked channel 2 ?
You will need to reassign the trigger to it too so to get a stable waveform.
JiaRen:
yep, same issue. Set the trigger already aswell.
tautech:
Have you swapped probes ?
Just a piece of wire from the probe compensation terminal into the channel input should display the correct waveform with a 1V/div and 500us/div.

Is there any sign that the input BNC's have suffered an impact ?
JiaRen:
Yep, swapped probes, but no havent tried a piece of wire into the BNC, I'll try that.
 THe BNC connector has no sign of impact, so it was weird.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod