Products > Test Equipment

Siglent SDS-1202X-e waveform issues

<< < (4/8) > >>

JiaRen:
My friend that sent me the gift said that the Main board must have been damaged during shipment. Best bet now is to get a replacement board from siglent.

tautech:
Ok so have you checked channel 2 ?
You will need to reassign the trigger to it too so to get a stable waveform.

JiaRen:
yep, same issue. Set the trigger already aswell.

tautech:
Have you swapped probes ?
Just a piece of wire from the probe compensation terminal into the channel input should display the correct waveform with a 1V/div and 500us/div.

Is there any sign that the input BNC's have suffered an impact ?

JiaRen:
Yep, swapped probes, but no havent tried a piece of wire into the BNC, I'll try that.
 THe BNC connector has no sign of impact, so it was weird.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod