Products > Test Equipment

Siglent SDS1000X-HD - Bugs and "features" thread.

<< < (4/10) > >>

BreakingOhmsLaw:

--- Quote from: ZigmundRat on April 06, 2024, 02:49:25 am ---Presence of an RTC does not necessarily obviate the use of NTP (SNTP)  :)

--- End quote ---
I'd even argue that having an RTC is all the more reason to support NTP.

BreakingOhmsLaw:

--- Quote from: skander36 on April 05, 2024, 10:27:28 am ---1. yes the FFT screen update slows down for 2 seconds when menu is activated (even is embedded or floating). Tolerable, not an issue.

--- End quote ---
It's gotten better with 1.1.3.1, but still worth looking into IMHO, since it might be the same reason why the Bode Plot function is so dreadfully slow. The menu is always on during Bode Plot, so the function might suffer from the same issue.

BreakingOhmsLaw:
Aaaaaand it's dead...

Acquisition now has a permanent failure where everything between ground and the signal is filled with a pseudo 250MHz sine wave.


Probe Ch.1 is connected to cal signal, Probe Ch.2 is attached to ground.
I am not able to recover from this so far.

Update: I was able to recover the normal operation by reinstalling the firmware.

skander36:
How was crashed?
You were in the middle of something?

BreakingOhmsLaw:

--- Quote from: skander36 on April 06, 2024, 04:58:39 pm ---How was crashed?
You were in the middle of something?

--- End quote ---

I was playing arround  with the Bode Plot function and FFT. Then I shut down the unit and went for lunch.
When I returned, it  immediately started up in that state.
When this fault is active, it looks like it ia trying to interpolate anything into a 250MHz sine wave. It also combines all the samples from all channels into one trace. Really looks like the entire acquisition goes bonkers.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod