Products > Test Equipment
Siglent SDS1000X-HD - Bugs and "features" thread.
Martin72:
5 minutes....Pah.
Just under 50 minutes and you'll be in my class. :-X 8) :P
--- Quote ---Also waveform update does not seem to be faster, but I will keep measure in future.
L.E. In dots mode I have obtained 128 K.
--- End quote ---
The information in the data sheet only refers to a "sweet spot", a time base and certain settings anyway.
In the meantime, I've made my peace with it as long as it doesn't drop too much above and below the sweet spot.
skander36:
Before the update was about 10- 12 min. I don't remember precisely ...
uliano:
I didn't see this listed so I guess my unit is broken |O
Only channel 2 and only close to 0V vertical offset
https://youtu.be/DJZdw0w934E
tautech:
--- Quote from: uliano on November 12, 2024, 06:11:54 am ---I didn't see this listed so I guess my unit is broken |O
Only channel 2 and only close to 0V vertical offset
https://youtu.be/DJZdw0w934E
--- End quote ---
FW version ?
Latest is:
https://int.siglent.com/upload_file/zip/firmware/Oscilloscope/SDS1000X-HD_V1.1.3.8_EN.zip
Have you done a Default ?
Run Self Cal too.
uliano:
I have latest and did self cal.
What's a default?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version