Products > Test Equipment
SIGLENT SDS1072CML (v5.01.02.22) next firmware feature requests
<< < (11/13) > >>
tautech:

--- Quote from: Sobakin76 on March 06, 2021, 11:55:54 pm ---By the way, the 1204X-E shows a bit more detailed waveform than 1152CML with same probe and at same 1GSa/s

--- End quote ---
Normal.
CML HW is limited by its 150 MHz HW whereas SDS1kX-E HW is 200 MHz capable and as there are far greater HF components in a square wave the CML's HW will not reproduce it as accurately.

Dig out the thread: Show us your square wave and have a look at how different scopes handle the HF component.
Sobakin76:

--- Quote from: tautech on March 07, 2021, 12:09:28 am ---Normal.Dig out the thread: Show us your square wave and have a look at how different scopes handle the HF component.
--- End quote ---
Oh I haven't more good scopes. I have 3rd scope for outdoor usage, but it's a $100 40Mhz Hantek 2C42 with 250MSa/s sampling (in single channel mode), so it can't do anything good with this waveform (used PP80B probe shipped with scope):

Maybe we need another thread for this topic? :)
Sobakin76:
I founde that probe calibrated at 1204X-E has some overshoot on calibration square wave then connected to older 1152CML, looks like the old one has a bit smaller input capacitance, despite it marked 16pF vs 15pF at 1204X-E, if I understand the concept correctly (I may not).
la-xara:
Hello friends, how to do generating code.

Sent the SCPI command
MCBD xxxxxxxxxxxxxx

1. Before Patch
*IDN? => *IDN SIGLENT,SDS1072CML,S/N,5.01.02.32

2. Right after patch and reboot
*IDN? => *IDN SIGLENT,SDS104X,S/N,5.01.02.32

1and 2. this is i do success! 

Help me
la-xara:
Hello friends!
Thank you very much for you help tv84!
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod