Products > Test Equipment

SIGLENT SDS1072CML (v5.01.02.22) next firmware feature requests

<< < (11/13) > >>

tautech:

--- Quote from: Sobakin76 on March 06, 2021, 11:55:54 pm ---By the way, the 1204X-E shows a bit more detailed waveform than 1152CML with same probe and at same 1GSa/s

--- End quote ---
Normal.
CML HW is limited by its 150 MHz HW whereas SDS1kX-E HW is 200 MHz capable and as there are far greater HF components in a square wave the CML's HW will not reproduce it as accurately.

Dig out the thread: Show us your square wave and have a look at how different scopes handle the HF component.

Sobakin76:

--- Quote from: tautech on March 07, 2021, 12:09:28 am ---Normal.Dig out the thread: Show us your square wave and have a look at how different scopes handle the HF component.
--- End quote ---
Oh I haven't more good scopes. I have 3rd scope for outdoor usage, but it's a $100 40Mhz Hantek 2C42 with 250MSa/s sampling (in single channel mode), so it can't do anything good with this waveform (used PP80B probe shipped with scope):

Maybe we need another thread for this topic? :)

Sobakin76:
I founde that probe calibrated at 1204X-E has some overshoot on calibration square wave then connected to older 1152CML, looks like the old one has a bit smaller input capacitance, despite it marked 16pF vs 15pF at 1204X-E, if I understand the concept correctly (I may not).

la-xara:
Hello friends, how to do generating code.

Sent the SCPI command
MCBD xxxxxxxxxxxxxx

1. Before Patch
*IDN? => *IDN SIGLENT,SDS1072CML,S/N,5.01.02.32

2. Right after patch and reboot
*IDN? => *IDN SIGLENT,SDS104X,S/N,5.01.02.32

1and 2. this is i do success! 

Help me

la-xara:
Hello friends!
Thank you very much for you help tv84!

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod