Products > Test Equipment

SIGLENT SDS1102CML - First Impressions

<< < (21/27) > >>

mcinku:

--- Quote from: tautech on April 06, 2014, 08:46:17 pm ---Confirm you Firmware version is the latest. If you scope is doing everything else correctly, it might be a firmware bug.

--- End quote ---

My SW Version is 5.01.02.22
HW 11-62-3 5

mcinku:

--- Quote from: Deckert on April 07, 2014, 12:02:38 am ---I suspect your math voltage scale is not set to the same scale as the other two channels. Select the math channel and go to page two of the setup. There are two options: one for setting the vertical position and the second to set the vertical resolution. Make sure it is not set to nV :)
--deckert

--- End quote ---

Ufff that's might be it, I didn't played with those options. Well I don't even know what those options are for... I didn't read the manual.

I know I know RTFM!!   |O

I will report back.
 ;)

mcinku:
That was it, that little knob is a bit sensitive but it does the job.
Thank you!

Regards

001:
Is serial number disappears or not (after flashing Siglent SDS7102CML with WaveAce 1012 firmware)?
Where I can find config file for LeCroy firmware?
Thanx!

Retro:
Hi has anyone sorted the Language not saving as I have the same problem with the SDS1102CML
Cheers

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod