| Products > Test Equipment |
| SIGLENT SDS1102CML - First Impressions |
| << < (22/27) > >> |
| tautech:
--- Quote from: Retro on September 11, 2014, 07:22:56 pm ---Hi has anyone sorted the Language not saving as I have the same problem with the SDS1102CML --- End quote --- After 5 or 10 startups the language option sets and remains with the language option you have chosen. Sorry I can't remember for sure, I think 10. It is this way so a seller can check or demonstrate the scope then ship to a buyer anywhere in the world. |
| Retro:
Thanks for the reply But when I press System Status it says system has been restarted 34 times and still the language has to be set on boot. software version 5.01.02.22 hardware version 11-62-3.5 Regards |
| geonicz:
You can load a config file. This solves the problem with language menu. Unpack it to flash drive with FAT32 system and plug it into scope. Press "Save|Recall ->type(Factory) -> Update Cfg". Select the *.cfg file and you're done. |
| pascal_sweden:
Just wondering when reading the comment about the reboot counter. Is there any way you can clear this counter or reset it to factory 0? This would come in handy for people experience the language issue, as they can then start with clean counter, and refer to the value later on, as fair indicative value for using the scope. |
| Siglent:
--- Quote from: pascal_sweden on October 09, 2014, 08:25:31 pm ---Just wondering when reading the comment about the reboot counter. Is there any way you can clear this counter or reset it to factory 0? This would come in handy for people experience the language issue, as they can then start with clean counter, and refer to the value later on, as fair indicative value for using the scope. --- End quote --- Dear Sir, Do you mean the frequency counter? the frequency function can be turn off. |
| Navigation |
| Message Index |
| Next page |
| Previous page |