Products > Test Equipment

SIGLENT SDS1102CML - First Impressions

<< < (6/27) > >>

Wuerstchenhund:

--- Quote from: rf-loop on May 16, 2013, 06:55:33 pm ---I think and also believe that Siglent also listen customers.  I have seen some changes what are clearly collected from customers opinions.
--- End quote ---

I was thinking of collecting bug reports and improvement suggestions, put it in a document and send this to them. I really like this little scope and it would be a real shame if the software side would let it down.

Do you have any contact email for Siglent that is actually active and which could be used for this?

Wuerstchenhund:

--- Quote from: rf-loop on May 16, 2013, 06:42:19 pm ---many times I have told that manufacturer NEED arrange useability test group who look also things in some time points when design is going forward
--- End quote ---

What manufacturers should do is to involve a Human Factors/UI specialist in the design phase. Unfortunately most good software developers are just awful UI designers (and most mediocre programmers are simply shit at UI design, just look at the mass of very poor websites).

rf-loop:

--- Quote from: Wuerstchenhund on May 16, 2013, 07:14:02 pm ---
--- Quote from: rf-loop on May 16, 2013, 06:55:33 pm ---I think and also believe that Siglent also listen customers.  I have seen some changes what are clearly collected from customers opinions.
--- End quote ---

I was thinking of collecting bug reports and improvement suggestions, put it in a document and send this to them. I really like this little scope and it would be a real shame if the software side would let it down.

Do you have any contact email for Siglent that is actually active and which could be used for this?

--- End quote ---

Yes I have.

But I will ask also if they have better contact just directly for this Oscilloscope specials.
(last time I have talked about SDG's some things and I do not know exactly if they have separate team for oscilloscope things. But least also my direct contacts can forward these to right persons inside Siglent)  I will PM it after I know.

Also I have some kind of "wish" list + bug list.... but it is not at all ready yet due to lack of time.

rf-loop:

--- Quote from: Wuerstchenhund on May 16, 2013, 07:18:51 pm ---
What manufacturers should do is to involve a Human Factors/UI specialist in the design phase. Unfortunately most good software developers are just awful UI designers (and most mediocre programmers are simply shit at UI design, just look at the mass of very poor websites).

--- End quote ---

I confirm this.

| Signature and stamp |

hgg:
I have found the source of the 50hz noise.
The oscilloscope was plugged on a mains power meter. 
I don't know how, but that meter was causing the 50hz noise...

Perfect flat line now down to millivolts!   :-+

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod