Products > Test Equipment
SIGLENT SDS1102CML - First Impressions
<< < (14/27) > >>
bjoernx:

--- Quote from: rf-loop on September 06, 2013, 02:27:23 pm ---
--- Quote from: sameerdhiman on September 06, 2013, 09:59:50 am ---
Actually, they are right to some extent because the noise floor is too high and you won't see harmonic contents in the noise grass other than high Hum signals.

--- End quote ---

And you have data for this?


Opinions are opinions and joking is joking but I respect data.

--- End quote ---

sameerdhiman was probably referring to the noisefloor in LOL terms: ratio of bad jokes with broken punch-lines lying around on the floor, prematurely deceased and misunderstood for life.  O0


--- Quote from: rf-loop on September 06, 2013, 02:27:23 pm ---Also this same test can repeat where ever lab.

--- End quote ---

Nice testcase, thank you! As said, I'll have to get my head around this to find out, how it can be useful to me.

I will test this scope some more over the weekend and finally decide, wether to return it or not. Think I've found quite a few bugs and glitches so far, will see if I can repeat and screenshot them and will report back here if time permits.

sameerdhiman:
I apologies, It was purely a joke. Please don't take it otherwise.

I apologies again.

No doubts, Siglent device is good. I do not regret after purchase. After all this is my first DSO.

BTW, in my scope waveform does not align to center (0,0 coordinates) it always remain shifted few point to left side even after Self-
Calibration. Is it normal?

Regards,
Sameer
zoltan:
Hi there,

Today I become a proud owner of one brand new Siglent SDS1102CML.

This one is:
SW 5.01.02.22
HW 11-62-3.5

The very first annoying thing i've found is that the damn thing won't remember the language setup. It will remember the channel choice etc. but not the language.
Maybe if I set it to chinese  :-DD

Zbig:

--- Quote from: zoltan on September 09, 2013, 07:11:50 pm ---Hi there,

Today I become a proud owner of one brand new Siglent SDS1102CML.

This one is:
SW 5.01.02.22
HW 11-62-3.5

The very first annoying thing i've found is that the damn thing won't remember the language setup. It will remember the channel choice etc. but not the language.
Maybe if I set it to chinese  :-DD

--- End quote ---

Hmm, my SDS1072CML SW5.01.02.13/HW11-62-3.3 does remember the language preference correctly. A 5.01.02.22 bug, perhaps?
johansen:
My SDS1102CNL

5.01.02.13
hardware version
11-62-3.3

i've read through several other threads..
you can buy the memory chip for 23$ off mouser solder it in, and then upgrade it to CML
and from what i read the only difference between the CML and CNL is the configuration file, not the software...
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod