| Products > Test Equipment |
| SIGLENT SDS1102CML - First Impressions |
| << < (16/27) > >> |
| johansen:
this is a 1102CNL, which is apparently equivalent to other scopes, for example, CML, etc take a close look an notice the skew, and the fact that it missed several data points. at 500MS/S per channel , it should capture 25 samples per division per channel. not so. in fact, you might be able to say it is capturing 10 data points per division, or it can't tell the difference between the LSB. buy an analog scope if you want to know for certain what is going on. note the decay rate and you should see something is seriously wrong. |
| echen1024:
--- Quote from: johansen on September 19, 2013, 09:18:42 am --- this is a 1102CNL, which is apparently equivalent to other scopes, for example, CML, etc take a close look an notice the skew, and the fact that it missed several data points. at 500MS/S per channel , it should capture 25 samples per division per channel. not so. in fact, you might be able to say it is capturing 10 data points per division, or it can't tell the difference between the LSB. buy an analog scope if you want to know for certain what is going on. note the decay rate and you should see something is seriously wrong. --- End quote --- Are you sure your probe attenuation is set correctly? |
| kenw232:
I'm trying to get EasyScope working for my Siglent SDS-1052DL so I can take screenshots of the LCD waveform. I figure the best way is to see it on my laptop unless someone knows if I can take a screenshot with the SDS-1052DL by itself? Anyway I can't get WindowsXP to install a driver for EasyScope when I plug the Siglent into the USB port. XP wants to install a driver but I have no idea where to tell it to get the driver. I installed NIVISA 5.3 but that did not help. SDS-1052DL Software Version: 5.06.0216 Hardware Version: 11-62-2.6 Anyone have any idea where to actually get the USB driver for this thing? |
| kenw232:
Forget it, I figure it out. The scope can save a BMP to a memory stick on the fly. If anyone knows how I can freeze the waveform I'm seeing on the LCD so I can save it when I'm ready do tell. They shoot by too fast for me to click the Print button. Thanks. |
| johansen:
press the single button? or configure the trigger properly? |
| Navigation |
| Message Index |
| Next page |
| Previous page |