Products > Test Equipment
SIGLENT SDS1102CML - First Impressions
tautech:
Siglent are on line right now. Send them a PM.
Don't forget to share your results with us. :)
cheloski:
Thanks a lot... Fortunately, I have repaired the problem ..... I sent a mail with my problem to Siglent.eu , where I have bought the oscilloscope , and I received a fast answer ........ After power on , I have to pressed a lot of time the key "math" , after that the oscilloscope start normally.... He sayed me to put the English language like default (before have Spanish), may be the problem stay there.....I will continue using the unit, I hope not to have more problems....
tautech:
Siglent frequently read this forum and will note problems for future tweaks to firmware.
We all must remember to post problems so they are aware of them. ;)
mcinku:
Hi,
I just bought SDS1102CML scope a few days ago and still learning about all the features of this scope.
While playing with the scope I found one strange issue... I was hopping if anybody can test this on his scope. I want to find out if perhaps I have a faulty scope or maybe I'm doing something wrong here.
I'm feeding 1k sine wave inverted signals on both channels. When I'm trying to use sum function, I'm expecting to get a flat line but what I get is... :wtf:
tautech:
I would suggest you ZERO the trigger level and check other trigger settings. I can try myself if you have no luck.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version