| Products > Test Equipment |
| SIGLENT SDS1102X-C, supported languages issue |
| << < (10/15) > >> |
| tv84:
Michael, Go again to the link I showed and download the sys_cfg_1104_X-C_ENG.zip file. That's the one you should put in your machine. |
| MichaelEE:
Thank you very much. Now also Product type is SDS1104X-C. Great! |
| alexkg:
Hello! I got a Siglent SDS 1202X-C device. I ask you for help on how to reflash it and get the opportunity to change the interface language. From previous posts, I understood what you need: 1) download the configuration file. I can't and don't know how to do it. 2) you can update to the file posted here. But I could not update the file from the USB flash drive. What I've done. I downloaded the cfg file to replace it with a flash drive, but I couldn't install it. What am I doing wrong? Please, if possible, explain to the delitant how to perform these procedures. Step by step if possible. Thanks in advance. |
| Othman:
Dear alexg you should know some basics of Linux/Telnet to get the job done! if you don't have Linux on your PC you can use Putty or you can activate the Linux Terminal on windows check this: https://allthings.how/how-to-use-linux-terminal-in-windows-10/ i will summarize the steps with some details. i would to mention that this way might be not the best way to do it but it is the one that worked with me. the steps are as the following: 1- load the older FW version SDS1002X-E_1.3.17R1_EN on your SDS1202X-C scope. because with the newest FW you can't establish telnet connection with your scope "the port 9999 is closed" you can find the old version here: https://siglentna.com/service-and-support/firmware-software/digital-oscilloscopes/#sds1000x-e-series 2- connect your scope with a router or a switch by ethernet cable don't forget to enable the DHCP server in your scope lan configuration and notice what is the IP address of your Scope. 3- connect your PC with the same router or the same switch then open Linux terminal on your PC or Putty terminal and try to establish a telnet connection as a root with your scope in order to access the file Systems. type this command : telnet <your scope IP> 9999 the user name is "root" the password is "siglent_sds1000x_e" 4- copy the file "sys_cfg.cfg" in this direction "./usr/bin/siglent/firmdata0/sys_cfg.cfg" to your USB disk, you should know some basic Linux command to explore, copy, delete and mount a drive to do this job. 5- share this file with "TV84" to do the magic job then you will replace the file with the new one that might "TV84" offer you. 6- check if every thing is going well then update the FW to the new one again the newest version is 1.3.26. |
| tv84:
--- Quote from: Othman on January 07, 2023, 01:49:20 pm ---5- share this file with "TV84" to do the magic job then you will replace the file with the new one that might "TV84" offer you. --- End quote --- No need to do this step. You just need to overwrite with the appropriate file (attached by me in a previous msg). The .cfg are the same for all scopes in the same situation. Make sure you rename the intended file to "sys_cfg.cfg" before overwriting, and sync. |
| Navigation |
| Message Index |
| Next page |
| Previous page |