| Products > Test Equipment |
| SIGLENT SDS1102X-C, supported languages issue |
| << < (11/15) > >> |
| Othman:
--- Quote from: tv84 on January 07, 2023, 08:41:37 pm --- No need to do this step. You just need to overwrite with the appropriate file (attached by me in a previous msg). The .cfg are the same for all scopes in the same situation. Make sure you rename the intended file to "sys_cfg.cfg" before overwriting, and sync. --- End quote --- i thought the CFG of SDS1202X-C model might be different from the SDS1102X-C. thanks for clarification. |
| alexkg:
--- Quote from: tv84 on January 07, 2023, 08:41:37 pm --- --- Quote from: Othman on January 07, 2023, 01:49:20 pm ---5- share this file with "TV84" to do the magic job then you will replace the file with the new one that might "TV84" offer you. --- End quote --- No need to do this step. You just need to overwrite with the appropriate file (attached by me in a previous msg). The .cfg are the same for all scopes in the same situation. Make sure you rename the intended file to "sys_cfg.cfg" before overwriting, and sync. --- End quote --- Do you need to overwrite the configuration file by executing commands in telnet? that is, connect to the device via telnet and give a command to replace the file? or can this be done from a flash drive in the oscilloscope menu? |
| tv84:
--- Quote from: alexkg on January 10, 2023, 08:02:45 am ---Do you need to overwrite the configuration file by executing commands in telnet? that is, connect to the device via telnet and give a command to replace the file? or can this be done from a flash drive in the oscilloscope menu? --- End quote --- Yes. So, it's better for you to ask for someone who knows linux to help you with hands-on. |
| alexkg:
I asked my friend to help me, he is familiar with Linux. There was a problem, when connecting to the device via Telnet, only port 23 is available. 9999 port is not available at all. When downgrading the firmware, as advised by Othman, port 9999 is still unavailable. How else can I access the device? are root correct? : username is "root" the password is "siglent_sds1000x_e" |
| tv84:
Use port 23 (default telnet port). ::) |
| Navigation |
| Message Index |
| Next page |
| Previous page |