Products > Test Equipment
Siglent SDS1104X-E and SDS1204X-E: Bode plot with a non-Siglent AWG
awakephd:
Excellent!
das_strobel:
--- Quote from: bateau020 on September 12, 2024, 01:01:05 pm ---I will take a look at the existing forks do an assessment of where to start from.
--- End quote ---
You have a pull request from me regarding the support of Rigol DG800/900/1000Z siggens. Let me know if it works for you. Thanks!
PS: I've sent the PR to this repo https://github.com/hb020/sds1004x_bode. I hope it is the right one?
bateau020:
Great! I knew there was something wrong with that correction, but hadn't taken the time yet to check it. Thanks.
Merged.
Knutselaar:
Best awakephd,
Did you change on line 12 of esp_config.h:
#define AWG FY3200
in
#define AWG FY6900
The last compiling I did was with the FY3200.
Knutselaar
bateau020:
@Knutselaar: the problem is that the espbode code uses TCP for both `rpc_server` and `lxi_server`. This works with the SDS1000 (non HD) series, but does not work with the newer HD series (SDS800 HD or SDS1000 HD), that awakephd has.
These newer scopes require UDP for `rpc_server`, and require dynamic changes to the port assigned to `lxi_server`. This is not really a big surprise: many other LXI/VXI devices have the RPC portmap service listening on TCP and UDP.
It however means that a rather serious adaptation of the espBode network code is needed in order to make it compatible with the HD series scopes.
Now I can help with that, the code is not that complicated. But this would need to be a group effort, as I no longer have a SDS1000 (non HD) series scope, and I do not have a serially controlled AWG (although all of that can be simulated). As a result, I really prefer to do so via github, not via zip files.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version