Products > Test Equipment
Siglent SDS1104X-E and SDS1204X-E: Bode plot with a non-Siglent AWG
lololo:
hello, nice job!
I have a jds2900 and i would like to know if espbode is compatible? Apparently, it is the same as the jds6600, there is just the case that changes. Inside there is a connector that i could use with a level shifter to put an esp.
awakephd:
--- Quote from: lololo on November 17, 2024, 05:25:55 pm ---hello, nice job!
I have a jds2900 and i would like to know if espbode is compatible? Apparently, it is the same as the jds6600, there is just the case that changes. Inside there is a connector that i could use with a level shifter to put an esp.
--- End quote ---
Thanks! And yes, it should be possible to set up the jds2900 to work with espBode. The key is getting hold of the Serial/USB protocol. I tried to find a manual on-line, but thus far the only thing I've found wants to charge me to download it. The little bit I could see without paying looks like it uses a different protocol than the FY series - different, but shouldn't be any trouble to work with once I know what it is!
Do you have a copy of the communication codes / USB protocol / programming guide / whatever it is called? If so, if you could scan and send it to me (or send an electronic copy), that would be super helpful!
bateau020:
JDS6600 has an implementation in the python version (https://github.com/hb020/sds1004x_bode), so that might be a start. That device uses quite different commands from the fy devices. Example: ":w23=25786,0." sets the output frequency of channel 1 to 257.86Hz.
lololo:
Thanks for your answer, I will try the python version. (I confused JDS and FY 🤦♂️)
Here is the pdf of the protocol just in case :-D
Have a nice day.
bateau020:
First glance tells me it is rather similar to the JDS6600, so that driver might work. Let me know if you find any issues.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version