Products > Test Equipment

Siglent SDS1104X-E and SDS1204X-E: Bode plot with a non-Siglent AWG

<< < (6/35) > >>

Old Printer:
I have only had my 1104x-e a week now so still feeling my way along. Right now my best AWG is my Analog Discovery 2. While limited in frequency, it's other controls are pretty versatile. This has me wondering about the possibility to interface these two...

4x1md:

--- Quote from: Old Printer on April 24, 2019, 03:57:28 pm ---I have only had my 1104x-e a week now so still feeling my way along. Right now my best AWG is my Analog Discovery 2. While limited in frequency, it's other controls are pretty versatile. This has me wondering about the possibility to interface these two...

--- End quote ---
It may be possible but I'm not familiar with this device so I can't tell you more.

MikeLud:
I modified an ESP-01 Adapter as shown in photos below and I am having issues with communication. It work for about 30 seconds to a minute then I get the error shown in photo below. I tried several delay settings but had no luck. Does anyone know how to get it to work.

Thanks in Advance,

Mike

MikeLud:
MrTick

I added a Pull Request to fix a compile issue I had.

MikeLud:
I figured out what was causing my communication issues. It was having the scope set to DHCP, once I set the scope to a static IP it works like a charm. Below are some photos of the final setup.

4x1md & MrTick,

Thanks for all of your hard work on this great non-Siglent AWG hack. :-+

Mike

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod