Products > Test Equipment
Siglent SDS1104X-E and SDS1204X-E: Bode plot with a non-Siglent AWG
puterboy:
Will this work with a FeelTech 6900?
I.e. will the code for the 6800 also work for the 6900?
puterboy:
Hi Mike,
This is *really* cool.
I would love to create such a slick setup for my FeelTech 6900, but I am unsure of the details.
Would it be possible to summarize what you did, including:
1. What hardware/boards for the microcontroller as well as the UART & WiFi
2. What if any hardware hacking was needed?
3. What software version you used?
4. How you programmed the microcontroller?
5. How do I know if it's working? :)
I am a bit of Newbie here so would appreciate any help as it has been hard for me to glean the details from the various posts on this thread.
puterboy:
--- Quote from: MikeLud on April 28, 2019, 01:48:20 am ---I figured out what was causing my communication issues. It was having the scope set to DHCP, once I set the scope to a static IP it works like a charm. Below are some photos of the final setup.
--- End quote ---
Yes, there seems to be a bug with DHCP on the Siglent 1104/1204-X-E whereby it connects/disconnects intermittently but is rock stable with static IPs.
Here is a post on eeVblog where I did some troubleshooting on when/where the error occurs.
https://www.eevblog.com/forum/testgear/siglent-sds1104x-e-and-sds1204x-e-bode-plot-with-non-siglent-awg/
JamesLynton:
--- Quote from: Archades on September 28, 2020, 05:48:37 am ---Has anyone tried this with a Uni-T UTG962?
--- End quote ---
I'd like to see it done too, got one of these on the way as well as its a nice compact source for debugging stuff on the move; and with a nice ui to boot.
Having dug abit in the pc control software manual for it, it uses the USBTMC (USB Test and Measurement Class) protocol for remote control and editing, it shouldn't be too difficult to sniff those usb packets on sending those commands from the software to see exactly what it'd expect to implement similar.
Sigrok (the bus sniffer software project) links to the documentation for this standard here:
https://sigrok.org/wiki/USBTMC
and links to code used for working with the USBTMC SCPI protocol here:
https://sigrok.org/gitweb/?p=libsigrok.git;a=blob;f=src/scpi/scpi_usbtmc_libusb.c
jbaribeault:
I just picked up a UNI-T UTG962E as well. Ready/willing to run anything required to help with the effort - this is a nice little unit and would go AWESOME with my SDS1204X-E....
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version