Products > Test Equipment

Siglent SDS1104X-E and SDS1204X-E: Bode plot with a non-Siglent AWG

<< < (13/35) > >>

timkoers:
I updated the code of espBode to include the FY6900. I also opened a merge request but that doesn't seem to get merged any time soon.

https://github.com/timkoers/espBode

masterx81:

--- Quote from: timkoers on December 08, 2020, 07:11:19 pm ---I updated the code of espBode to include the FY6900. I also opened a merge request but that doesn't seem to get merged any time soon.

https://github.com/timkoers/espBode

--- End quote ---
Thanks! I have ordered my 1104x-e, so now that i can connect it to my fy6900 👍👍

jbaribeault:
How fast does the signal gen need to react to the commands from the scope? Myself and a few others managed to get python sending commands to the UNI-T 962G but the only thing they've implemented is button pushes and on a single one at a time - fastest we seem to be able to set a new waveform is about 0.85 seconds. Is this going to be fast enough or do the waveforms need to change faster than that?

masterx81:
ESP-01 (espbode) + FY6900 works perfectly!
Love it!
Thanks for your work!
In past i've used microchip mcu where you had only few KB of flash and some byte of ram, it's incredible how powerful is this esp-01 little thing 😱

masterx81:
I think that there must be a bug on the esp code (both forks), I'm trying to set a sweep with center frequency 20MHz, 5MHz wide, and the esp hang, also stop responding to ping (seem stuck in a loop). I've still not attached the logic analyzer to see what's going on...
Little question, as i'm not familiar with arduino projects... How can be debugged this thing? The tx/rx pins are connected to the awg so i can't output anything   :-BROKE

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod