Products > Test Equipment
Siglent SDS1104X-E In-Depth Review
<< < (21/48) > >>
tautech:

--- Quote from: Performa01 on May 21, 2018, 10:31:59 pm ---
--- Quote from: tautech on May 21, 2018, 09:39:27 pm ---Interesting, thanks.
So no apparent input attenuation indicator added into the channel tab.  :-//

Can you share any discussion with R&D as to why that wasn't considered after we've discussed that in detail ?

--- End quote ---

Sorry, but I cannot remember that I'd ever been involved in such a discussion, hence cannot know if and what has been considered by Siglent R&D.

It sounds like you have requested something, but then I would rather expect you to know the status. What am I missing?

--- End quote ---
It was WRT 1202X-E but applies to all Siglent models and I thought you'd seen all this.....yes we've emailed about a few things but didn't discuss this in detail.
Starts here
https://www.eevblog.com/forum/testgear/siglent-technical-support-join-in-eevblog/msg1373837/#msg1373837
On same issue here
https://www.eevblog.com/forum/testgear/here_s-how-bad-siglent_s-(sds1104x-e)-gui-is/msg1471679/#msg1471679

In actual use it's not so necessary as when you hit a channel button to enable control with this multiplexed setup the input attenuation is plainly visible in the selected channel menu.
However for documentation, screenshots could offer much more info if the input attenuation was visible on all channel tabs. This would be a great improvement to all Siglent models that run the V2 FW and with careful implementation input attenuation could be shown on each channel tab.
toli:

--- Quote from: Performa01 on May 21, 2018, 12:38:23 pm ---The most impressive thing is the new web server though. We now get a playful Teletubby-like user interface, but much more importantly a real time update for the DSO screen. This works really well and allows true remote operation. The screen refresh rate appears quite high and it actually feels like looking at the real DSO screen – just bigger.

Screen Save now stores in PNG format, which is very welcome.


SDS1004X-E New Web Server

--- End quote ---

Thanks for the update here. I've just ordered a unit with the MSO option, and some of these things will come in handy. One place where a larger screen can be great is when working with multiple digital signals + analog channels, where you need the extra resolution.
Is the resolution of the remote display identical to physical scope screen or is it higher (lower?)?
Does it keep all the front panel control active while using this remote control program?
What interface are you using for the control? LAN/USB/wifi?
tautech:

--- Quote from: toli on May 22, 2018, 05:46:01 am ---Does it keep all the front panel control active while using this remote control program?

--- End quote ---
Yes.

--- Quote ---What interface are you using for the control? LAN/USB/wifi?
--- End quote ---
Any of the above can control the scope but the webserver is accessible only to LAN and WiFi.
It's as simple as configuring the IP address.
toli:
thank you.

any idea about the resolution of the display in this mode?
tautech:

--- Quote from: toli on May 22, 2018, 06:29:06 am ---thank you.

any idea about the resolution of the display in this mode?

--- End quote ---
TBH we'd all be guessing until this new FW is released publicly.
Just checked the 3 Siglent sites I use and it's only on the Chinese one as yet.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod