Author Topic: 10811-80111  (Read 210 times)

0 Members and 1 Guest are viewing this topic.

Offline tchiwam

  • Regular Contributor
  • *
  • Posts: 54
  • Country: ca
« on: January 23, 2021, 03:39:27 pm »
OK, seems that 10.0000000009 +/- 6µHz is the best I can get for now... that is after 24h warm up. The 1st 3 hours were all over the place.

I am using a PRS10 as a reference, but I suspect that the 10MHz distribution has a lot of jitter... need to investigate...
The trim pot on this one is not that friendly, just tapping the screw like a mini impact in the direction you need makes a big difference.

Oh yeal and use an isolated screw driver, or a ceramic one if you can. The screw is part of the circuit.


Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo