Products > Test Equipment
Siglent SDS2000 new V2 Firmware
Performa01:
--- Quote from: rf-loop on December 16, 2015, 07:21:48 am ---I'm not sure but looks like that also independent of history playback interval time setting.
--- End quote ---
Yes, that's what I found too. As I wrote, it also happened at 10ms interval, which is much slower than what the scope can do.
--- Quote from: rf-loop on December 16, 2015, 07:21:48 am ---My version is
FW: 1.2..1.28.1
FPGA: 15.11.17-15.11.17-15.11.26
HW: 3-3
Model: SDS2304
--- End quote ---
So our firmware and FPGA program are identical, only the hardware differs (mine is 5-3).
tautech:
--- Quote from: Performa01 on December 16, 2015, 08:31:08 am ---
--- Quote from: rf-loop on December 16, 2015, 07:21:48 am ---I'm not sure but looks like that also independent of history playback interval time setting.
--- End quote ---
Yes, that's what I found too. As I wrote, it also happened at 10ms interval, which is much slower than what the scope can do.
--- Quote from: rf-loop on December 16, 2015, 07:21:48 am ---My version is
FW: 1.2..1.28.1
FPGA: 15.11.17-15.11.17-15.11.26
HW: 3-3
Model: SDS2304
--- End quote ---
So our firmware and FPGA program are identical, only the hardware differs (mine is 5-3).
--- End quote ---
rf-loop's and mine are both pre-release dealer units model SDS2304 HW: 3-3 and are missing the MSO port and associated componentry, but same PCB AFAIK as the 5.3 HW.
rf-loop:
--- Quote from: tautech on December 16, 2015, 08:37:14 am ---rf-loop's and mine are both pre-release dealer units model SDS2304 HW: 3-3 and are missing the MSO port and associated componentry, but same PCB AFAIK as the 5.3 HW.
--- End quote ---
Yes. There mey be some tiny mechanical/HW "adjustments" in official marketing versions after pre-release version.
Example some pre versions may have extra noise in channels. This is because aluminium is not always easy material due to surface oxide layer. If there is extra noise and unit is pre version, there may need tiny mod around internal aluminium chassis and input BNC's. Contact from inteernal aluminium chassis and BNC GND surface is not very good.
I have never seen this problem in official market versions after pre "demo"version.
Siglent America:
Hello, Performa01.
I just thought I would let you know that the Siglent SDS2000(X) product engineering people have been reading your posts on this thread. They are currently working on the issues you have noted.
Thanks for your help.
Marchello:
--- Quote from: Siglent America on December 16, 2015, 01:40:28 pm ---Hello, Performa01.
I just thought I would let you know that the Siglent SDS2000(X) product engineering people have been reading your posts on this thread. They are currently working on the issues you have noted.
Thanks for your help.
--- End quote ---
Hello!
When SDS2074X will be available for purchase?
Best regards!
Mark.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version