Products > Test Equipment
Siglent SDS2000 new V2 Firmware
euforia51:
--- Quote from: gejianyong on March 12, 2023, 05:37:11 am ---Hello, my oscilloscope model is SDS2034. I want to turn on the decoding and signal generator functions of this oscilloscope to get the correct accessory serial number
Do you have a way?
--- End quote ---
Hello... first time post question. I've been following the blog for a while looking for a solution to re-enable the AWG for my SDS2104X.
Same issue as above.
I want to enable the AWG and other options if possible. The AWG is a priority.
Following the blog, I learned my scope does not have a built in web server.
And therefore, I cannot enable these options so easily, if at all.
I've had the scope for several years now and did not realize when I purchased it that the AWG was on a temporary license.
It was finally disabled about a month or so ago. I used it a lot and rarely turned it off.
Hopefully, someone can help. I didn't want to start a new topic as I'm pretty sure this has been covered in many threads.
But maybe there's a way I haven't seen yet.
Thanks very much!
MetalHead:
Hello guys!
my scope is SDS2102 (without X)
after FW update to 1.2.2.2 the scope stuck on black screed and cannot jump to "Siglent" logo any more..
Past FW ver: SDS2000-V2.0-1.02.01.28R1
Upgrade to: 1.2.2.2 (last one)
the upgrade process went ok, but after restart it does not load any more... ((
What can be done in this situation?
tautech:
--- Quote from: MetalHead on October 18, 2024, 12:30:20 pm ---Hello guys!
my scope is SDS2102 (without X)
after FW update to 1.2.2.2 the scope stuck on black screed and cannot jump to "Siglent" logo any more..
Past FW ver: SDS2000-V2.0-1.02.01.28R1
Upgrade to: 1.2.2.2 (last one)
the upgrade process went ok, but after restart it does not load any more... ((
What can be done in this situation?
--- End quote ---
Try this:
https://siglentna.com/operating-tip/oscilloscope-hardware-reset/
MetalHead:
--- Quote from: tautech on October 18, 2024, 02:07:09 pm ---
--- Quote from: MetalHead on October 18, 2024, 12:30:20 pm ---Hello guys!
my scope is SDS2102 (without X)
after FW update to 1.2.2.2 the scope stuck on black screed and cannot jump to "Siglent" logo any more..
Past FW ver: SDS2000-V2.0-1.02.01.28R1
Upgrade to: 1.2.2.2 (last one)
the upgrade process went ok, but after restart it does not load any more... ((
What can be done in this situation?
--- End quote ---
Try this:
https://siglentna.com/operating-tip/oscilloscope-hardware-reset/
--- End quote ---
No, it does not help. It seems that right when it should show "Siglent" logo it gets stuck.
tv84:
--- Quote from: MetalHead on October 18, 2024, 04:50:50 pm ---the upgrade process went ok, but after restart it does not load any more... ((
--- End quote ---
Did you followed all the instructions as they are inside the FW package of this post?
https://www.eevblog.com/forum/testgear/siglent-sds2000-new-v2-firmware/msg4750610/#msg4750610
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version