Products > Test Equipment
Siglent SDS2000X HD, missing Features and Bugs
temperance:
@ Tautech
The probes are set to x1 after you press the default button and they are recognized as x10 probes after unplugging.
KungFuJosh:
--- Quote from: temperance on March 22, 2024, 02:16:46 am ---@ Tautech
The probes are set to x1 after you press the default button and they are recognized as x10 probes after unplugging.
--- End quote ---
Yup. The bug has been reported for every model that can sense probes. Unplug and replug them in, or manually set them to x10. It's the only thing that really annoys me with the scope.
temperance:
An other enhancement I would like to see is the ability to set the horizontal offset at a fixed position.
Let's say you set the offset to -80 µs with 20 µs /div. When the time base is adjusted to 10 µs/div, the offset should should be adjusted to -40 µs. As it is now, the offset is constant and the trigger position is off screen. That's not practical and I have to adjust the offset all the time.
2N3055:
--- Quote from: temperance on March 22, 2024, 12:51:39 pm ---An other enhancement I would like to see is the ability to set the horizontal offset at a fixed position.
Let's say you set the offset to -80 µs with 20 µs /div. When the time base is adjusted to 10 µs/div, the offset should should be adjusted to -40 µs. As it is now, the offset is constant and the trigger position is off screen. That's not practical and I have to adjust the offset all the time.
--- End quote ---
In Utility-> System-> Reference position you can choose Horizontal Ref to be "Delay" or "Position".
When set to Position timeframe will compress/expand around set Position.
I believe you are now in Delay mode.
temperance:
--- Quote ---In Utility-> System-> Reference position you can choose Horizontal Ref to be "Delay" or "Position".
When set to Position timeframe will compress/expand around set Position.
I believe you are now in Delay mode.
--- End quote ---
Thank you very much. It's even in the manual... But not under chapter 8.3 where they discuss the horizontal controls but under 32.2.6 "32.2.6 Reference Position Setting.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version