Products > Test Equipment

Siglent SDS2000X HD, missing Features and Bugs

<< < (76/76)

Tjuurko:
Awg System Info
Model: SAG1021
Firmware Version: 1.11
Hardware Version: 0-4-6
Output Load: High-Z
OVP: on
SyncOut: off
Zero Adjust: manual -2.1mV

The WaveGen output is connected by the cable to the entrance "C1".
In "DC", everything works fine: the voltage is adjustable from -3.00V to +3.00V.

A strange feature was discovered: with an increase in the signal amplitude of more than 633mVpp, an additional offset of the output voltage appears by ~57mV.
When the output signal changes 632mVpp <-> 633mVpp, the operation of the inner relay is heard.

This is happening only with me or is this error in the firmware?
As a spare option, I have SDG2042X.


[ Specified attachment is not available ]

KungFuJosh:
Feature request: option to remember probe settings independently between V and A modes per channel.

Example: 1x set for a probe on V mode using a coax cable. Switch to A and use any custom user setting (0.1A/V or whatever). Switch back to V and be back to 1x.

Thanks,
Josh

Tjuurko:
Software Version: 1.2.2.9

First attempt to save an inverted image without a menu.
The following attempts were successful.

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod