Products > Test Equipment

Siglent SDS2000X Plus - Bugs / Missing Features / Feature Requests

<< < (148/206) > >>

knudch:
I just wonder why a brand new scope behave different
And time setting does not work here only, manual is ok

I will say BUG !

Knud



--- Quote from: KungFuJosh on June 10, 2023, 01:44:44 pm ---
--- Quote from: knudch on June 10, 2023, 09:19:00 am ---@Martin72

Mine is even more stranges

Dont have the LAN tab in that window
In the TIME tab the Time zone is blank and I can not chose any timezone

Firmware 5.0.1.5.2R2 and 2R3  (2104X plus => all options)
Connected to LAN with DHCP or Fixed IP

Knud

--- End quote ---

Go to Utility -> I/O Setting, and you should see LAN config there.

I also have the latest firmware, and cannot select Timezone at all. Time works fine anyway though.

--- End quote ---

blurpy:
Siglent does not provide the time zone files in firmware upgrades, so those who bought the scope before the feature was added can not set a time zone. New scopes have those files in place from the factory. Still hope Siglent will provide those files in the future, but we have been waiting a while now.

KungFuJosh:

--- Quote from: blurpy on June 11, 2023, 10:05:21 am ---Siglent does not provide the time zone files in firmware upgrades, so those who bought the scope before the feature was added can not set a time zone. New scopes have those files in place from the factory. Still hope Siglent will provide those files in the future, but we have been waiting a while now.

--- End quote ---

That's interesting. If that's the case, then maybe somebody with the time zone files can copy them off of their scopes to make them available to the rest of us.

blurpy:

--- Quote from: KungFuJosh on June 11, 2023, 04:44:04 pm ---That's interesting. If that's the case, then maybe somebody with the time zone files can copy them off of their scopes to make them available to the rest of us.

--- End quote ---
They also disabled the usual telnet trick that would have made that "easy" in newer firmware versions, so that's a bit unfortunate.
It's better if they finish the rollout of the feature in a supported proper way.

Looking at you tautech ;)

KungFuJosh:
I guess this is a feature request, since I can't find a way to do it (and I don't want to RTFM again).

I want to be able to compare two frequencies on a bode plot. For example, I'd like one marker at 200Hz, and the 2nd marker at the peak. I'm running 80/dec for the resolution I need, and they don't both fit in the list on screen.

It would also be nice if there were more measurement options in bode plots. For example...comparing the peak to a specific frequency. 😉

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod