Products > Test Equipment
Siglent SDS2000X Plus - Bugs / Missing Features / Feature Requests
KungFuJosh:
--- Quote from: tautech on June 19, 2023, 08:11:53 pm ---Reference file format is not CSV !
You need Save as a Reference file to your preferred destination and point Recall to it.
--- End quote ---
How do you suggest I do that, if Bode Plots only save data as CSV? The only option is to change the filename, not file type.
Martin72:
Like I wrote before, Bode is it´s own "universe" when active...you can´t do anything else... :P
But what I did a few minutes ago is:
-bode plotting ch2
-Data--save--ch2
-bode plotting again, but now with ch4 as dut output
-Check that no content from ch2 was avaible, yes, no content.
-Then recall the data from ch2
-Trace visibility ch2 on.
Now you have ch2 as a kind of reference.
KungFuJosh:
This is what I'm actually trying to do:
For now I've created this template in Excel, and it will work. Though it would be nice if the scope were capable of doing this on its own. Other people are using a crappy software scope that can do this by itself.
Martin72:
Measure no load, save the curve.
Measure loaded, save the curve.
Measure inductance, then load the prior saved curves, then you´ll have all three curves(conditions) on the screen.
Or do I miss something ?
KungFuJosh:
--- Quote from: Martin72 on June 21, 2023, 08:07:31 pm ---Measure no load, save the curve.
Measure loaded, save the curve.
Measure inductance, then load the prior saved curves, then you´ll have all three curves(conditions) on the screen.
Or do I miss something ?
--- End quote ---
From your suggestion, I would need to keep swapping the probe channel correct? If I do that 3 times, will it give me the option to choose peaks for all 3 plots? And show the data?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version