Products > Test Equipment

Siglent SDS2000X Plus - Bugs / Missing Features / Feature Requests

<< < (156/206) > >>

KungFuJosh:

--- Quote from: Martin72 on June 21, 2023, 08:45:10 pm ---If I remember it right, the full data content will be saved.

--- Quote ---I would need to keep swapping the probe channel correct?
--- End quote ---
Yes, so my thoughts.
Now it is a little late (22h44) to check it for me, maybe tomorrow early evening - or you try it first. ;)

--- End quote ---

Unfortunately, that method didn't work for me at all. I ran plots on CH1 and CH2 separately, and then tried recalling the data. It only shows one at a time for me, alternating back and forth.

It's only capable of showing the list of test points from 1 channel at a time, and the cursors can also only do one channel at a time.

It gets more tedious because switching channels on the plot config forgets load and amplitude (likely other things too). More steps to forget the parameters for good comparison. Did I measure high or low impedance at 3Vpp or 5Vpp? Who knows, the scope won't remember for me. 😉 Edit: it might have been exiting and reentering bode plot to setup the channel settings to match, since I couldn't do that within the bode plot universe. Either way, it needs to remember settings better.

I copied and pasted the saved data into my Excel template, and here's how it's supposed to be:

KungFuJosh:
I dunno if this is a bug exactly, but...

My old Default key settings had CH1 set to a 1x probe. My probe in CH1 is an auto-sense 10x probe. Pressing Default set CH1 to 1x ignoring the auto sense. I obviously changed the default to 10x to avoid future nuisances, but it seems odd to me that hitting the Default key would ignore the auto-sense feature of the scope/probe(s).

Electro Fan:
Missing Feature / Feature Request

Maybe already suggested/requested:

10 MHz In, 10 MHz Out

Would be nice to take clock from GPSDO

Maybe on the next version:  SDS2000X Plus MkII ?

KungFuJosh:
Feature Request:

Ability to change the number of divisions.

For example, instead of 8 div vertical scale, we could change it to 10.

krasimir.k:
Hi,
I tried to use the mask feature with saved mask file : does not work. After the loading of the saved xxx.smsk file, the vertical range is reset to the minimum and the small part of the mask is visible on the top of the screen.
Used FW version : V1.5.2R1
Used scope : SDS2104X Plus

I tried to load the mask file from python - the loading is not happen at all.


--- Code: ---import pyvisa
#https://siglentna.com/wp-content/uploads/dlm_uploads/2023/04/SDS-Series_ProgrammingGuide_EN11D.pdf

rm = pyvisa.ResourceManager()
inst = rm.open_resource("TCPIP::10.35.89.136::INSTR")
print(inst.query("*IDN?"))

inst.write(":MTESt ON")
inst.write(":MTESt:MASK:LOAD EXTernal,\"local/mask.smsk\"")
inst.write(":MTESt:OPERate ON")

--- End code ---


Kind Regards,
Krasi

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod