Products > Test Equipment
Siglent SDS2000X Plus - Bugs / Missing Features / Feature Requests
mathstudi:
--- Quote from: 2N3055 on April 02, 2024, 03:34:37 pm ---Not in the doc yet AFAIK...
That is brand spanking new feature right from the oven.....
I don't have SDS2000X+.
What protocols are supported : I2C and SPI ?
--- End quote ---
Supported protocols are I2C and SPI.
Analysis -> Serial Signal Test.
Haven't tested the new function yet. I'll wait for the adapted documentation.
Mahagam:
ARINC decoder was added (trial).
Parameters setup:
Paul_GD:
New UI update seems to lack anti-aliasing and the padding is also off, buttons are harder to press with fingers now..
I hope this will be reverted to be in the style of 1.5.3 :o
2N3055:
--- Quote from: mathstudi on April 02, 2024, 03:58:10 pm ---
--- Quote from: 2N3055 on April 02, 2024, 03:34:37 pm ---Not in the doc yet AFAIK...
That is brand spanking new feature right from the oven.....
I don't have SDS2000X+.
What protocols are supported : I2C and SPI ?
--- End quote ---
Supported protocols are I2C and SPI.
Analysis -> Serial Signal Test.
Haven't tested the new function yet. I'll wait for the adapted documentation.
--- End quote ---
These are what is called compliance tests.
They will automatically test number of critical parameters of protocol and compile a PASS/FAIL test report with data.
Mahagam:
Small changes in FFT. Now we can find dF and RBW separately, and horizontal sweep can be switched log10/linear
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version