| Products > Test Equipment |
| Siglent SDS2000X Plus - Bugs / Missing Features / Feature Requests |
| << < (189/206) > >> |
| hpw:
Three bug seen on V1.6.2: [1] reboot and have setup as C2 & F1: you will see for a while the NOT enabled C1 input and than alters to C2 & F1 [2] using this setup: on the right side an 500Hz vertical line is drawn. See picture with red rectagle [3] If you enable on C2 the axis text as level & time as I use right justify: the level Y axis text gets overwritten by the trace line |
| mathstudi:
--- Quote from: 2N3055 on April 02, 2024, 03:34:37 pm --- --- Quote from: mathstudi on April 02, 2024, 03:58:10 pm ---.. Haven't tested the new function yet. I'll wait for the adapted documentation. --- End quote --- These are what is called compliance tests. They will automatically test number of critical parameters of protocol and compile a PASS/FAIL test report with data. --- End quote --- I actually wanted to wait for the updated documentation. But the interest in the new function was greater and so today I ran some tests with an I2C protocol. I am impressed! I've been looking for something like this for a long time, especially for the popular I2C and SPI protocols. This is exactly what I appreciate about Siglent, that even years after the market launch, new gadgets are still being added. The "fail" with the "Clock Signal Frequency" is my mistake -> wrong configuration. A report can also be generated (HTML/XML), which is quite impressive. I will do further tests. |
| mon:
Did 1.6.2 get yanked? Everywhere I checked is still 1.5.2R3 (int.siglent.com, siglentna.com, and siglent.com) |
| james38:
Yes, there were some problems (freezes) with the upgrade for some, so the update has been withdrawn until further notice. I think we have to wait here for now. Regards Chris |
| BitBangingBytes:
That’s a bummer! I discovered my VNC no longer works properly after upgrading to the latest 1.5 version and found this thread where others seemed to have the same issue. Hopefully the 1.6 version goes public soon so I can see if that fixes it. |
| Navigation |
| Message Index |
| Next page |
| Previous page |