Products > Test Equipment
Siglent SDS2000X Plus vs SDS2000X HD
<< < (5/5)
tautech:

--- Quote from: Electro Fan on April 03, 2024, 03:06:34 am ---And just to confirm this is all doable…

“The 2000X HD will decode on both the analog and digital channels in binary (1s and 0s, not just Hex or ASCII), both below the waveform and in the table view (for UART, I2C, SPI, etc.)?”

--- End quote ---
I think so but haven't got one to check for sure......
Others will advise.
Performa01:

--- Quote from: Electro Fan on April 03, 2024, 12:18:24 am ---Just wanted to ask if the the 2000X HD will decode on both the analog and digital channels in binary (1s and 0s, not just Hex or ASCII), both below the waveform and in the table view (for UART, I2C, SPI, etc.)?  Thanks

--- End quote ---
Yes, it does hex, binary, decimal and ASCII for all protocols and it makes no difference whether analog and digital input channels are used.
blurpy:

--- Quote from: Performa01 on April 03, 2024, 06:31:52 am ---
--- Quote from: Electro Fan on April 03, 2024, 12:18:24 am ---Just wanted to ask if the the 2000X HD will decode on both the analog and digital channels in binary (1s and 0s, not just Hex or ASCII), both below the waveform and in the table view (for UART, I2C, SPI, etc.)?  Thanks

--- End quote ---
Yes, it does hex, binary, decimal and ASCII for all protocols and it makes no difference whether analog and digital input channels are used.

--- End quote ---
Note that it won't decode parallel signals in ASCII, only serial.
See this discussion: https://www.eevblog.com/forum/testgear/new-scope-demoboard-from-batronix/msg5175123/#msg5175123
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod