Products > Test Equipment
Siglent SDS5000X Vertical Calibration Issue
(1/2) > >>
EEVblog:
tautech:
Did you have the Quick Cal feature OFF or ON ?

Here's the latest FW version should you need to get it up to date:
https://int.siglent.com/upload_file/zip/firmware/Oscilloscope/SDS5000X_V0.9.9R6_EN.zip
EEVblog:

--- Quote from: tautech on August 23, 2024, 04:41:20 am ---Did you have the Quick Cal feature OFF or ON ?

--- End quote ---

No idea about that feature at all, can't find any such option.
What does it do?

tautech:

--- Quote from: EEVblog on August 23, 2024, 07:28:43 am ---
--- Quote from: tautech on August 23, 2024, 04:41:20 am ---Did you have the Quick Cal feature OFF or ON ?

--- End quote ---

No idea about that feature at all, can't find any such option.

--- End quote ---
TBH I don't remember if SDS5000X has Quick Cal or it came later.
Replaced mine with SDS6204A.

--- Quote ---What does it do?
--- End quote ---
As it implies, a quick cal while the scope warms to normal operating temp.
Generally ~2s pause while the cal is done/checked.
EEVblog:

--- Quote from: tautech on August 23, 2024, 07:51:36 am ---As it implies, a quick cal while the scope warms to normal operating temp.
Generally ~2s pause while the cal is done/checked.
--- End quote ---

Is that just offset, or is it vertical gain as well?
How many scopes cal for vertical gain anyway?
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod