Products > Test Equipment

Siglent SDS5000X Vertical Calibration Issue

(1/2) > >>

EEVblog:

tautech:
Did you have the Quick Cal feature OFF or ON ?

Here's the latest FW version should you need to get it up to date:
https://int.siglent.com/upload_file/zip/firmware/Oscilloscope/SDS5000X_V0.9.9R6_EN.zip

EEVblog:

--- Quote from: tautech on August 23, 2024, 04:41:20 am ---Did you have the Quick Cal feature OFF or ON ?

--- End quote ---

No idea about that feature at all, can't find any such option.
What does it do?

tautech:

--- Quote from: EEVblog on August 23, 2024, 07:28:43 am ---
--- Quote from: tautech on August 23, 2024, 04:41:20 am ---Did you have the Quick Cal feature OFF or ON ?

--- End quote ---

No idea about that feature at all, can't find any such option.

--- End quote ---
TBH I don't remember if SDS5000X has Quick Cal or it came later.
Replaced mine with SDS6204A.

--- Quote ---What does it do?
--- End quote ---
As it implies, a quick cal while the scope warms to normal operating temp.
Generally ~2s pause while the cal is done/checked.

EEVblog:

--- Quote from: tautech on August 23, 2024, 07:51:36 am ---As it implies, a quick cal while the scope warms to normal operating temp.
Generally ~2s pause while the cal is done/checked.
--- End quote ---

Is that just offset, or is it vertical gain as well?
How many scopes cal for vertical gain anyway?

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod