Products > Test Equipment

Siglent SHS800X/SHS1000X/SDS logger sample files

(1/3) > >>

thetooth:
Looking to write some open source software for parsing siglent .slg and .mlg logger files. I have the binary format documentation but no way to test since the SHS1102X I've ordered is at least 3-4 weeks out. If anyone here owns one of these scopes or a similar era siglent that outputs these formats, can you post a sample log file for me to play with?  Duration or sample rate doesn't matter. Cheers

tautech:

--- Quote from: thetooth on January 28, 2023, 05:01:24 am ---If anyone here owns one of these scopes or a similar era siglent that outputs these formats, can you post a sample log file for me to play with?  Duration or sample rate doesn't matter. Cheers

--- End quote ---
Sure. SHS820X here.
Maybe something from an AWG is easy for me. Tell me what you'd like to see.
.sig and .mig files we'll have to bluff the forum to accept by adding .txt as an extension that you'll need to remove.

thetooth:

--- Quote from: tautech on January 28, 2023, 07:57:15 am ---
--- Quote from: thetooth on January 28, 2023, 05:01:24 am ---If anyone here owns one of these scopes or a similar era siglent that outputs these formats, can you post a sample log file for me to play with?  Duration or sample rate doesn't matter. Cheers

--- End quote ---
Sure. SHS820X here.
Maybe something from an AWG is easy for me. Tell me what you'd like to see.
.sig and .mig files we'll have to bluff the forum to accept by adding .txt as an extension that you'll need to remove.

--- End quote ---

Whatever you like really, I'd like to play around with calculating measurements like RMS and crest factor from the waveform data too so maybe a mains voltage recording and just some simple stuff like a square wave and sine from the AWG.

tautech:
Just getting onto this now.
We have 3 types of log files in these:
Scope Sample or Measure logging plus Meter (DMM) logging mode.
In Meter logging the fastest rate is 100ms.

Further only Binary, CSV and Matlab file types are available, which for Binary the BIN2CSV conversion utility is available from the Save/Recall menu.

Exactly what logging types would you like to see thetooth ?

thetooth:
I'm after the bin types (.slg and .mlg files), from the scope inputs. Bonus if you can get one with two channels of data. You will probably have to upload elsewhere though since it appears that these files have 16MB of padding before any of the data actually gets recorded lol.

Attached is my first experiments in converting samples into measured values offline, ignore the scale of the waveform as that's just simulated raw ADC values.

Navigation

[0] Message Index

[#] Next page