Products > Test Equipment
Siglent SPD3303D review
<< < (25/35) > >>
FrankBuss:
Sounds like your unit is broken, but warranty should cover this.
Renae:

--- Quote from: Siglent America on October 27, 2015, 01:29:33 pm ---Hi Frank.

I sent your suggestion and drawings to Engineering and received this response from the VP of Engineering- below.
Thanks again for your good suggestions!
Steve
<<<<

Hi Steve
 
    The guy's suggestions are  good. I very like this kind of feedback. I will remember his name,Leonerd
 
    The suggestion of improve the control way of setting knob, we had implemented the similar way as he suggesed in new SPD3000X power supply.
    About suggestion of display the set value and actual output value in the screen at same time, we think it is a good idea. I had discussed with Owen and our enigneer , and we will implement it in the next SPD3000X firmware.
 
--- End quote ---
Hi Steve,

Thanks for getting out there and answering questions about your products.

I see there appears to be a firmware that was released just before your post above and I suspect the update you are referring to would be in the next update. Do you know when there will be another firmware update for the X series implementing the aforementioned graphical update? I too would find it immensely useful to see the current setting in addition to the current reading. I'm also curious about adjustment in the hundredths. I was looking at the D version just before purchasing and I saw there was an update in January for the D version but for some reason I did not check the X version. Well, I changed my mind to get the X version partially based on your post. I just now checked the X firmware date and saw, as mentioned above, there has been no update for a while.

Thanks again
Siglent America:
Hi, FrankBuss, Ranae, and others.

We are about ready to release the new FW that shows both the programmed settings as well as the actual output values.

We'd like your opinion on which screen User Interface you prefer. Please see the three attached screen shots and let us know which one you prefer (UI-1, UI-2, UI-3) and we will use that one in our new FW.
Thanks
Steve
rosbuitre:

--- Quote from: Siglent America on March 15, 2016, 12:49:38 pm ---Hi, FrankBuss, Ranae, and others.

We are about ready to release the new FW that shows both the programmed settings as well as the actual output values.

We'd like your opinion on which screen User Interface you prefer. Please see the three attached screen shots and let us know which one you prefer (UI-1, UI-2, UI-3) and we will use that one in our new FW.
Thanks
Steve

--- End quote ---

UI-1  :-+

regards
Chupacabras:

--- Quote from: Siglent America on March 15, 2016, 12:49:38 pm ---Hi, FrankBuss, Ranae, and others.

We are about ready to release the new FW that shows both the programmed settings as well as the actual output values.

We'd like your opinion on which screen User Interface you prefer. Please see the three attached screen shots and let us know which one you prefer (UI-1, UI-2, UI-3) and we will use that one in our new FW.
Thanks
Steve

--- End quote ---
I have SPD3303X-E and any of those 3 options are better than current one.
I like UI-3 and UI-2. (edit: I think UI-2 is less logical according to physical connectors than UI-3)
But I have a challenge for you: make it changeable in setup so user can choose any of it :)
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod