Products > Test Equipment
Siglent SPD3303D review
<< < (10/35) > >>
jimjam:
Instead of pressing the button longer, perhaps it could be just a normal press to change the "cursor" position. Each time it's pressed, it would cycle through 1V, 0.1 and 0.01 (and 0.001 for the 3303S model)
FrankBuss:
Right, cycling would be even better, because the same concept for both models. The current step size could be displayed on the graphics display.
jimjam:

--- Quote from: psycho0815 on October 17, 2013, 03:29:17 pm ---I really don't like the fact that i can't set a current limit on the 5V channel. I know i can use ch1 or 2 at 5V but still. Just doesn't seem thought through.

--- End quote ---
I just noticed this. Does CH3 have any short circuit protection?
FrankBuss:
Yes, ch3 is limited to 3 A max. and short circuits are no problem.
ScottyAU:
I've just ordered one from a local supplier here in Australia who says there stock is only a few weeks old.

Will post back when it arrives.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod