Products > Test Equipment

Siglent SPD3303D review

<< < (10/35) > >>

jimjam:
Instead of pressing the button longer, perhaps it could be just a normal press to change the "cursor" position. Each time it's pressed, it would cycle through 1V, 0.1 and 0.01 (and 0.001 for the 3303S model)

FrankBuss:
Right, cycling would be even better, because the same concept for both models. The current step size could be displayed on the graphics display.

jimjam:

--- Quote from: psycho0815 on October 17, 2013, 03:29:17 pm ---I really don't like the fact that i can't set a current limit on the 5V channel. I know i can use ch1 or 2 at 5V but still. Just doesn't seem thought through.

--- End quote ---
I just noticed this. Does CH3 have any short circuit protection?

FrankBuss:
Yes, ch3 is limited to 3 A max. and short circuits are no problem.

ScottyAU:
I've just ordered one from a local supplier here in Australia who says there stock is only a few weeks old.

Will post back when it arrives.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod