Products > Test Equipment

Siglent SPD3303X-E Hi-Resolution Output Unlock?

<< < (10/25) > >>

tv84:

--- Quote from: mawyatt on July 20, 2021, 06:24:04 pm ---No luck using the CLREEPROM command, CC offset still remains!!

--- End quote ---

Did you notice that anything else got reset?

mawyatt:
Used the CLREEPROM command followed by the CALCLS 8 command hoping to clear the CC offset. The model and serial number were not reset, so not sure what was reset with the CLREEPROM command.

Best,

tv84:
Mike, last call:

Send the command

FACTORY ON

before issuing the  CLREEPROM.

Report if it changed anything.

mawyatt:
Tried the FACTORY ON, then the CLREEPROM, no change. Then tried FACTORY (mentioned in thread blurpy pointed to) and then CLREEPROM, no change.

Best,

blurpy:
Running out of ideas here. Curious to hear what Siglent has to say. It's probably fixable in firmware. Seems likely as mentioned earlier that it's an offset that's out of expected range, and the code doesn't handle it.

It could be that CLREEPROM either does nothing at all, or tries to call the code behind CALCLS which doesn't work.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod