Products > Test Equipment
Siglent SVA1015X Hack?
(1/4) > >>
js671:
Hi folks,

Long time reader, first time poster - sorry!!

Had anyone come up with a Rigol style hack to enable all the options (or reset the trial countdowns) on the SVA1015X. I haven't seen anything around, there is a file hack for the SSA series (I think) but not sure if thats the same software.

Cheers!
tautech:

--- Quote from: js671 on May 09, 2019, 08:40:10 am ---Hi folks,

Long time reader, first time poster - sorry!!

Had anyone come up with a Rigol style hack to enable all the options (or reset the trial countdowns) on the SVA1015X. I haven't seen anything around, there is a file hack for the SSA series (I think) but not sure if thats the same software.

Cheers!

--- End quote ---
Welcome to the forum.

Have a careful look here:
https://www.eevblog.com/forum/testgear/siglent-ads-firmware-file-format/

And there's also some clues later on in the SVA1015X thread.
js671:
Thanks Tautech.

The SSA3xxx hack is confirmed working on the SVA1015X & enables all options except the DTF & VNA with the permanent license   :-DD

Now, does anyone know the trick for the VNA & DTF without spending £££s? I'm off to look at that thread you sent over!

SW1 2.1.1.1.12.a
SW2 20180701-0
SW3 0000000CA
HQ 02.01.00

plug in FAT32 formatted USB memory stick (to take a backup).
telnet to SSA30xxX
root/ding1234

cd /   
cp -R /usr/bin/siglent/usr/backup /usr/bin/siglent/usr/mass_storage/U-disk0/SA-backup
cp -R /usr/bin/siglent/firmdata0 /usr/bin/siglent/usr/mass_storage/U-disk0/SA-firmdata0
mount -o remount,rw /dev/ubi2_0 /usr/bin/siglent/firmdata0
cd /usr/bin/siglent/firmdata0
mv NSP_sn_bandwidth.xml NSP_sn_bandwidthx.xml
mv NSP_trends_config_info.xml NSP_trends_config_infox.xml   
mv nsp_data_b nsp_data_bx   
cd /usr/bin/siglent/usr/backup   
mv NSP_sn_bandwidth.xml NSP_sn_bandwidthx.xml
mv NSP_trends_config_info.xml NSP_trends_config_infox.xml
mv nsp_data_b nsp_data_bx
cd /
sync   
logout

reboot
js671:
After applying the SSA procedure above I have everything except the VNA & DTF - those are still counting down the trial. This leads me to believe that the licence info / file to liberate is not one of the usual XML files from the SSA & that the SVA needs slightly different tactics, but despite a lot of thread reading on here I’ve not yet found them.  :palm:

Also tried today to replace the licence info removing the Lower case ‘t’ and changing the remain figure - all that did was throw everything else back to trial. Damn.
dc8wan:
Hi js671,

have you found a better solution for hacking the SNA1015X?

regard dc8wan
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod