Products > Test Equipment
Siglent SDS1052DL+ / SDS1102CML+ hack
<< < (18/19) > >>
oz2cpu:
sorry to kick this thread alive again..
but I find no other threads about SDS1102CML hack

new trick : i was not able to connect via putty, correct ip number, tribble checked it was corrent,
none of the mentionened ports, SSH or telnet, no way. also checked with nmap where they could be..

The solution : get siglent software EasyScopeX
this will connect to the scope just fine,
its command interface also accept the hack code, and you can up the bandwidth that way
Toolworker:
I can connect to my SDS1102CML+ on the LAN with EasyScopeX, and ping it, but can not Telnet to it even after rebooting with startup.sh on the USB drive, or bring up the IP address in a browser.

The firmware version is 6.01.01.22, the 8/6/21 update.

Any suggestions?
tautech:

--- Quote from: Toolworker on December 18, 2021, 02:31:45 am ---I can connect to my SDS1102CML+ on the LAN with EasyScopeX, and ping it, but can not Telnet to it even after rebooting with startup.sh on the USB drive, or bring up the IP address in a browser.

The firmware version is 6.01.01.22, the 8/6/21 update.

Any suggestions?

--- End quote ---
Check item #4 on P13 of the programming guide:
https://siglentna.com/wp-content/uploads/dlm_uploads/2021/01/SDS1000-SeriesSDS2000XSDS2000X-E_ProgrammingGuide_PG01-E02D.pdf
Toolworker:

--- Quote from: tautech on December 18, 2021, 03:01:48 am ---Check item #4 on P13 of the programming guide:
https://siglentna.com/wp-content/uploads/dlm_uploads/2021/01/SDS1000-SeriesSDS2000XSDS2000X-E_ProgrammingGuide_PG01-E02D.pdf

--- End quote ---
Thanks. But that just opens an SCPI command processor, which can also be done with EasyScopeX through a LAN or USB connection.

After trying a couple of USB drives with startup.sh, I was finally able to telnet to a Linux login prompt with one of the drives.
tautech:
Oh, sorry. I knew some instruments need to have a port specified for access and believed 5024 was open for CML+. Then I found this:
https://siglentna.com/operating-tip/instrument-socket-and-telnet-port-information/
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod