Products > Test Equipment

Sniffing the Rigol's internal I2C bus

<< < (330/899) > >>

marmad:

--- Quote from: StepDIR on December 01, 2013, 05:54:27 pm ---Thanks Marmad but that is what I have been doing and it doesn't load.  I'll keep researching maybe someone else is having this problem.

--- End quote ---

Reformat the USB stick you're using and/or try a different USB stick.

Gallymimus:

--- Quote from: StepDIR on December 01, 2013, 05:54:27 pm ---Thanks Marmad but that is what I have been doing and it doesn't load.  I'll keep researching maybe someone else is having this problem.

--- End quote ---

Did you try a different flash drive?  Some people have had issues with large drives or certain brands.  You might just try a few different blank drives.

SeanB:
Definitely use a drive under 4G, preferably an older one of under 1G. I keep some older ones around because older firmware will not support large drives reliably or at all.

staze:
Some USB sticks don't work sometimes. I would try another.

Also, as for the checksum question, it would be good to have only to confirm the download and thumbdrive copy are intact. It at least cuts out a sanity question.

StepDIR:
I've tried two different USB sticks.  One is under 1G.
Tried FAT16 and FAT32.

Is the name of the GEL file important or just the fact that it is a GEL file enough?

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod