Products > Test Equipment
Sniffing the Rigol's internal I2C bus
neslekkim:
Is there an webserver inside this scope? lot of htmlcode inside the gel file?
"RIGOL Web-Enable DS2000 Series"
JDubU:
--- Quote from: neslekkim on December 03, 2013, 04:50:42 pm ---Is there an webserver inside this scope? lot of htmlcode inside the gel file?
"RIGOL Web-Enable DS2000 Series"
--- End quote ---
Yes.
After setting up the LAN IP addressing on the scope, you can access it's internal webserver from the network via a web browser.
It doesn't do very much though. Just shows things like model number, network addresses, VISA string, firmware revision, etc.
Rigby:
--- Quote from: AndersAnd on December 03, 2013, 01:48:44 pm ---
--- Quote from: alank2 on December 03, 2013, 01:42:02 pm ---Also, it isn't a rar but a zip you've attached.
--- End quote ---
I'm surprised WinRAR doesn't complain, regardless if this file ends on .rar or .zip.
It just opens it as if it had the correct extension name, whether you name it .rar or .zip.
--- End quote ---
This is what happens when you write your software to avoid clues on how to do things that may be provided by the operating system. You read the header of the actual file and determine what to do, rather than being told.
jboard146:
--- Quote from: JDubU on December 03, 2013, 05:19:07 pm ---
--- Quote from: neslekkim on December 03, 2013, 04:50:42 pm ---Is there an webserver inside this scope? lot of htmlcode inside the gel file?
"RIGOL Web-Enable DS2000 Series"
--- End quote ---
Yes.
After setting up the LAN IP addressing on the scope, you can access it's internal webserver from the network via a web browser.
It doesn't do very much though. Just shows things like model number, network addresses, VISA string, firmware revision, etc.
--- End quote ---
Does anyone know what the login is? If you click on the Network settings it asks for a login and password.
It would be nice if you could do stuff via the web interface.
AndersAnd:
--- Quote from: neslekkim on December 03, 2013, 04:50:42 pm ---Is there an webserver inside this scope? lot of htmlcode inside the gel file?
"RIGOL Web-Enable DS2000 Series"
--- End quote ---
You mean the LXI webpage? It's explained in the DS2000 User's Guide: http://www.rigol.com/download/Oversea/DS/User_guide/DS2000_UserGuide_EN.pdf
--- Quote ---Load LXI webpage
As this oscilloscope conforms to LXI-C standards, you can load LXI webpage through Ultra Sigma (right-click the resource name and select LXI-Web; or directly input the IP address in the browser). Various important information about the oscilloscope (including the model number, manufacturer, serial number, description, MAC address and IP address) will be displayed on the webpage as shown in the figure below.
--- End quote ---
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version