Products > Test Equipment

Sniffing the Rigol's internal I2C bus

<< < (364/899) > >>

stormbr:
Works fine with ds2072 (non a) and hardware 2.0.

Model: DS2302
SW: 00.02.01.00.03
HW: 1.0.2.0.2
FPGA: SPU 03.01.09 / WPU 00.07.01 / CCU 12.29.00 / MCU 02.12

Note:
Need uninstall the old key with ultra sigma.
Option: DSHH + rigen 2b1
Protocol analysis CAN: ok
300MHz BW: ok
BW limit: OFF - 20M - 100M

Thanks Cybernet.

alank2:

--- Quote from: stormbr on December 10, 2013, 02:49:36 am ---300MHz BW: ok

--- End quote ---

Did you test or measure this somehow?

stormbr:
No tested this bandwith yet, but some peoples here measure easily 300mhz, in future i'll bought a pulse generator too.

And i'm waiting my dsa815tg arrive, can i generate a 300mhz signal with dsa815?

ted572:

--- Quote from: stormbr on December 10, 2013, 03:15:51 am ---No tested this bandwith yet, but some peoples here measure easily 300mhz, in future i'll bought a pulse generator too.

And i wait my dsa815tg arrive, can i generate a 300mhz signal with dsa815?

--- End quote ---

Yes, you will be able to generate 300 MHz (or anything else up to 1.5 GHz) in the Zero Span Mode.

Rigol-Friend:

--- Quote from: stormbr on December 10, 2013, 03:15:51 am ---No tested this bandwith yet, but some peoples here measure easily 300mhz, in future i'll bought a pulse generator too.

And i'm waiting my dsa815tg arrive, can i generate a 300mhz signal with dsa815?

--- End quote ---

Sure, up to 1.5 Ghz (Zero Span).  -20 to 0 dBm in 1 dB steps.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod