Products > Test Equipment
Sniffing the Rigol's internal I2C bus
<< < (386/899) > >>
m-joy:
Huhu, where can i download the latest firmware for my DS2072?

Greets
Marc M.:

--- Quote from: m-joy on December 13, 2013, 08:13:48 am ---...where can i download the latest firmware for my DS2072?
--- End quote ---
It may have been posted somewhere earlier in the thread but this is where I downloaded it from.  See post# 1842.

--- Quote from: AndersAnd on December 10, 2013, 12:26:30 am ---...Just download the official firmware 00.02.01.00.03 uploaded here instead.
Then un-rar DS2000Update.GEL and load it.
After updating apply a key generated with DSAR DSHH to enable all options.

--- End quote ---
Be aware that so far I haven't been able to downgrade back to .02 from this version.  Refer to my post above regarding the issue.

Success!  Updated the post.
marmad:

--- Quote from: Marc M. on December 13, 2013, 08:44:59 am ---Be aware that so far I haven't been able to downgrade back to .02 from this version.  Refer to my post above regarding the issue.

--- End quote ---

As mentioned a few times earlier in this thread (and at the DS2000 Review thread), I (and others) have upgraded and downgraded between the versions several times - always by bootloading, and always taking care to clear the FRAM when next booting.
Tasman:
Do I need to uninstall my previously applied options before upgrading to the new firmware and applying the DSHH generated key?
marmad:

--- Quote from: Tasman on December 13, 2013, 09:42:30 am ---Do I need to uninstall my previously applied options before upgrading to the new firmware and applying the DSHH generated key?

--- End quote ---
I didn't, although I have an official key for the normal options; I just used cybernets DSEA for CAN decode.
So I don't think it's necessary to uninstall and reinstall all (since I don't think the FW can distinguish between official and "non-official" key codes) unless you want to do it that way.

But, more importantly: Rigol has changed the the structure of unit settings stored in FRAM, so if you upgrade/downgrade between the major versions (v.01.XX.XX.XX to v.02.XX.XX.XX - or vice-versa), it's highly recommended to hold in the left-menu F6 button (sixth gray button down on left side of LCD) during the first reboot after loading (to clear FRAM) - otherwise the DSO will hang (often) when switching between various menu items.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod