Products > Test Equipment
Sniffing the Rigol's internal I2C bus
<< < (394/899) > >>
elecBlu:
some tests of the real-world performance of the 300MHz Hack with Rohde & Schwarz SMS2 Generator (50Ohm).
I followed this procedure: https://www.eevblog.com/forum/testgear/sniffing-the-rigol%27s-internal-i2c-bus/msg347187/#msg347187
Looks good so far...
AndersAnd:
Nice. Have you measured the 3 dB cutoff frequency?
Rigol-Friend:

--- Quote from: elecBlu on December 14, 2013, 06:39:16 pm ---Rhode & Schwarz 

--- End quote ---

I never heard about that factory.     :o   :-DD
elecBlu:
did only direct comparison at the moment, but i can do some more tests soon.
And oops, little typo it is Rohde & Schwarz of course ;)

murdok:
Followed the thread since it started months ago, but have some questions now:

Can someone confirm that with latest SW (00.02.01.00.03) and enabled options on base of non-A DS2072 (HW v2), the selectable languages increased in count, but activating 50Ohm input option thru SCPI is no more working? (always prints note on screen: "invalid command" - whatever i try to put behind :CHANx:IMP)

Didn't try all combinations but i guess its independent of activated options.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod