Products > Test Equipment

Sniffing the Rigol's internal I2C bus

<< < (394/899) > >>

elecBlu:
some tests of the real-world performance of the 300MHz Hack with Rohde & Schwarz SMS2 Generator (50Ohm).
I followed this procedure: https://www.eevblog.com/forum/testgear/sniffing-the-rigol%27s-internal-i2c-bus/msg347187/#msg347187
Looks good so far...

AndersAnd:
Nice. Have you measured the 3 dB cutoff frequency?

Rigol-Friend:

--- Quote from: elecBlu on December 14, 2013, 06:39:16 pm ---Rhode & Schwarz 

--- End quote ---

I never heard about that factory.     :o   :-DD

elecBlu:
did only direct comparison at the moment, but i can do some more tests soon.
And oops, little typo it is Rohde & Schwarz of course ;)

murdok:
Followed the thread since it started months ago, but have some questions now:

Can someone confirm that with latest SW (00.02.01.00.03) and enabled options on base of non-A DS2072 (HW v2), the selectable languages increased in count, but activating 50Ohm input option thru SCPI is no more working? (always prints note on screen: "invalid command" - whatever i try to put behind :CHANx:IMP)

Didn't try all combinations but i guess its independent of activated options.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod