Products > Test Equipment
Sniffing the Rigol's internal I2C bus
<< < (406/899) > >>
m-joy:

--- Quote ---

 As soon as someone gets a dump of the firmware on the device of a DS2000A scope, it is very likely that the keygen will be modified to accommodate the newer model.


--- End quote ---

Maybe it will, maybe not...
cybernet:

--- Quote from: m-joy on December 17, 2013, 06:02:11 pm ---Maybe it will, maybe not...

--- End quote ---

http://www.pigpenpoetry.com/
barnacle2k:

--- Quote from: Rigby on December 17, 2013, 02:41:37 pm ---You have more reading to do.  As soon as someone gets a dump of the firmware on the device of a DS2000A scope, it is very likely that the keygen will be modified to accommodate the newer model.

Just take the time and read this entire thread.  It will take a while, yes.  You will learn many things if you don't rush it.

--- End quote ---

Rigol DS2072A - check
FTDI JTAG thingy - check

Now if anyone could get me short instructions which SW and commands i should use.
Since i am not sure what exactly gets URJtag or gdb to create the dump you guys need.
fcab100:
barnacle2k you have a DS2072A congrats on your new scope.  I was wondering if you could tell me what the jumper pins are set to on your scope.  Wanted to know if the its has changed.


Thanks Chris
bobn4burton:
So I just got my DS2102 and was preparing to use the keygen and unlock all options to get me to a DS2202.  I noticed that the 'all-options' code is now listed as DSHH??

I must have missed something in the last few weeks...but I believe the previous 'all-options' code was a DSAZ?

Which code should I be using to fully unlock my DS2102?

Also...most people are upgrading from a DS2072...I shouldn't  have any problems starting from a DS2102 should I?

Thanks in advance!
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod