Products > Test Equipment
Sniffing the Rigol's internal I2C bus
m-joy:
--- Quote ---
As soon as someone gets a dump of the firmware on the device of a DS2000A scope, it is very likely that the keygen will be modified to accommodate the newer model.
--- End quote ---
Maybe it will, maybe not...
cybernet:
--- Quote from: m-joy on December 17, 2013, 06:02:11 pm ---Maybe it will, maybe not...
--- End quote ---
http://www.pigpenpoetry.com/
barnacle2k:
--- Quote from: Rigby on December 17, 2013, 02:41:37 pm ---You have more reading to do. As soon as someone gets a dump of the firmware on the device of a DS2000A scope, it is very likely that the keygen will be modified to accommodate the newer model.
Just take the time and read this entire thread. It will take a while, yes. You will learn many things if you don't rush it.
--- End quote ---
Rigol DS2072A - check
FTDI JTAG thingy - check
Now if anyone could get me short instructions which SW and commands i should use.
Since i am not sure what exactly gets URJtag or gdb to create the dump you guys need.
fcab100:
barnacle2k you have a DS2072A congrats on your new scope. I was wondering if you could tell me what the jumper pins are set to on your scope. Wanted to know if the its has changed.
Thanks Chris
bobn4burton:
So I just got my DS2102 and was preparing to use the keygen and unlock all options to get me to a DS2202. I noticed that the 'all-options' code is now listed as DSHH??
I must have missed something in the last few weeks...but I believe the previous 'all-options' code was a DSAZ?
Which code should I be using to fully unlock my DS2102?
Also...most people are upgrading from a DS2072...I shouldn't have any problems starting from a DS2102 should I?
Thanks in advance!
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version