Products > Test Equipment
Sniffing the Rigol's internal I2C bus
fcab100:
--- Quote from: bobn4burton on December 18, 2013, 12:13:05 am ---So I just got my DS2102 and was preparing to use the keygen and unlock all options to get me to a DS2202. I noticed that the 'all-options' code is now listed as DSHH??
I must have missed something in the last few weeks...but I believe the previous 'all-options' code was a DSAZ?
Which code should I be using to fully unlock my DS2102?
Also...most people are upgrading from a DS2072...I shouldn't have any problems starting from a DS2102 should I?
Thanks in advance!
--- End quote ---
Use DSHH as it unlocks 300mhz with can decoding Make sure you have the latest fw update. The Fw (00.02.01.00.03) can be found at https://www.eevblog.com/forum/testgear/first-impressions-and-review-of-the-rigol-ds2072-ds2000-series-dso/
Bugware:
There is no problem to start from DS2102.
Use DSAZ for Firmware 00.01.01.00.02 to get 200MHz and all options.
Use DSHH for the brand new Firmware 00.02.01.00.03 (you can get it from here but read careful) to get 300MHz and all Options incl. CAN capability.
bobn4burton:
WOW...apparently I did miss something!
We can upgrade to 300Mhz now???
Has this been verified to be truly 300Mhz capable?
Sorry if I'm re-hashing...just haven't had to time stay up to date on this thread the last few weeks and thought I better check in before updating. And good thing I did...as we apparently got an even better upgrade than what I was planning...
alank2:
Why not DSGH ? has anyone found out what the DSBA bit does yet?
MrsR:
Hi! Guys,
Can someone HELP me.
I went right back through the thread and found the instructions to update my DS2072 to 200mHz.
I had to upgrade my FW used the one on the site and tried to change the trigger and speed it up.
Unfortunately it didn't work Just got incorrect code at the bottom of the screen on entering APPLY.
I have the memory updated to 56 megs purchased from EMONA before this thread started.
My Hardware Ver. is 1.000
and updated FW from 1.000.05 to 1.000.00.3 Zeros not accurately shown as I didn't copy it down from DSO.
CAN YOU HELP ME
Rachael
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version